W dniu 25.02.2013 18:33, Alf Birger Rustad pisze:
On Monday, February 25, 2013 01:27:17 PM Wojciech Kromer wrote:
Hello.
Next question about RB433GL is: how NAND is connected?
I've tried booth rb4xx and 4b750 nand driver, without success.
Where from someone knows how to write a driver for such board?
Hello Wojciech,
You will find the information on adding support for new nand chips here:
http://www.linux-mtd.infradead.org/doc/nand.html
Look under the section Supported chips. Check if support is already present in
new kernel if you haven't already done so.
Good luck!
Alf
OK, thank you.
I know infradead well.
Chip used on RB433GL is supported.
This is well known ST NAND512W3A.
Anyway there is a lot of non public documented magic
with Atheros CPU and board specific connections.
So there is a problem with chip access, not the nand-chip itself.
I probably need to write a new chip access driver,
but still looking for an information about board specific connections.
Best regards.
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
