Hi Hauke,
Am Do, 13.12.2012, 20:55 schrieb Hauke Mehrtens:
> On 11/11/2012 09:38 PM, Mathias Adam wrote:
>> ping...
>>
>> Am So, 14.10.2012, 21:13 schrieb Mathias Adam:
>>>
>>> !strcmp(getvar("status_gpio"), "1")) /* gpio based detection */
>>> return &platforms[PS1208MFG];
>>>
>>> + if (!strcmp(boardnum, "0x5347") && !strcmp(boardtype, "0x048e")) /*
>>> Huawei E970 */
>>> + return &platforms[HUAWEI_E970];
>>> +
>
> These two values boardnum and boardtype do not look very device
> specific, could you post the nvram of the device, I hope there are some
> better names in it.
here's nvram dump after a factory reset (serno, il0macaddr, boardno,
et0macaddr are device dependent):
CFE> nvram show
sdram_config=0x0062
sdram_refresh=0
vlan0ports=0 1 2 3 5*
et0mdcport=0
bxa2g=1
vlan1hwname=et0
ag0=2
et0phyaddr=30
serno=KQ7NAB18324.....
pa0maxpwr=72
pa0b0=0x125d
pa0b1=0xfb6e
pa0b2=0xfec1
il0macaddr=00:1E:10:10:..:..
wandevs=et0
clkfreq=240
cctl=0
sdram_ncdl=0xffd08
boardnum=0x5347
ccode=0
rssisav2g=2
boardno=020HQG7N830.....
rssismc2g=2
rxpo2g=0xfff8
opo=12
aa0=3
pa0itssit=62
sromrev=3
boardtype=0x048e
boardflags=0x750
watchdog=3000
lan_netmask=255.255.255.0
wl0id=0x4318
rssismf2g=0
boardrev=0x11
lan_ipaddr=192.168.1.1
et0macaddr=00:1E:10:10:..:..
et1phyaddr=0x1f
landevs=vlan0 wl0
build_cfe_version=256.11.01.03.102sp02
sdram_init=0x000b
boot_wait=on
tri2g=78
vlan1ports=4 5u
vlan0hwname=et0
xtalfreq=25000
wl0gpio0=11
wl0gpio1=11
wl0gpio2=11
wl0gpio3=11
size: 785 bytes (31983 left)
*** command status = 0
Regards,
Mathias
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
