Add switch setup to uci network defaults.
The 'lan' attribute is used to decide into which vlan to put the
port.
Currently 'disable' is never set, but the intention is to use this
for devices like the 8devices Carambola, which only has two ports
hooked up to the SoC.
Signed-off-by: Tobias Diedrich <ranma+open...@tdiedrich.de>
Index:
openwrt-ralink-swconfig/target/linux/ramips/base-files/etc/uci-defaults/network
===================================================================
---
openwrt-ralink-swconfig.orig/target/linux/ramips/base-files/etc/uci-defaults/network
2012-08-25 18:51:50.098398937 +0200
+++
openwrt-ralink-swconfig/target/linux/ramips/base-files/etc/uci-defaults/network
2012-08-25 18:52:07.278422933 +0200
@@ -9,6 +9,31 @@
return
fi
+ramips_setup_rt3x5x_vlans()
+{
+ if [ ! -x /sbin/swconfig ]; then
+ # legacy default
+ ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+ return
+ fi
+ local wanports=""
+ local lanports=""
+ for port in 5 4 3 2 1 0; do
+ if [ `swconfig dev rt305x port $port get disable` = "1" ]; then
+ continue
+ fi
+ if [ `swconfig dev rt305x port $port get lan` = "0" ]; then
+ wanports="$port $wanports"
+ else
+ lanports="$port $lanports"
+ fi
+ done
+ ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+ ucidef_add_switch "rt305x" "1" "1"
+ ucidef_add_switch_vlan "rt305x" "1" "$lanports 6t"
+ ucidef_add_switch_vlan "rt305x" "2" "$wanports 6t"
+}
+
ramips_setup_interfaces()
{
local board="$1"
@@ -74,7 +99,7 @@
*)
RT3X5X=`cat /proc/cpuinfo | grep RT3.5`
if [ -n "${RT3X5X}" ]; then
- ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+ ramips_setup_rt3x5x_vlans
else
ucidef_set_interfaces_lan_wan "eth0" "eth1"
fi
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
