Hey,guys! Here is my second patch for adding tplink tl-wr1041n v2 to openwrt. I
have found gpioes for system,wlan and wps.But the leds for wan and lan are
still not working because they are attached to ar8327.So I set the led for wps
indicating wan status. Please summit this patch,sign-off-by:Vince Huang. U-Boot
1.1.4 (Dec 31 2011 - 13:38:52) U-boot MI124 DRAM: 64 MB id read 0x100000ff
flash size 4MB, sector count = 64 Flash: 4 MB Using default environment In:
serial Out: serial Err: serial Net: ag934x_enet_initialize... No valid
address in Flash. Using fixed address wasp reset mask:c03300 WASP ----> S17
PHY * : cfg1 0x7 cfg2 0x7114 eth0: ba:be:fa:ce:08:41 athrs17_reg_init: complete
eth0 up eth0 Autobooting in 1 seconds ## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK Starting kernel ... [ 0.000000] Linux
version 3.3.3 (gzanan@qq810091899) (gcc version 4.6.3 20120201 (prerelease)
(Linaro GCC 4.6-2012.02) ) #1 Sun Apr 29 15:34:10 CST 2012 [ 0.000000]
bootconsole [early0] enabled [ 0.000000] CPU revision is: 0001974c (MIPS
74Kc) [ 0.000000] SoC: Atheros AR9342 rev 1 [ 0.000000] Clocks:
CPU:525.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz [ 0.000000]
Determined physical RAM map: [ 0.000000] memory: 04000000 @ 00000000
(usable) [ 0.000000] Initrd not found or empty - disabling initrd [
0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00004000 [
0.000000] Movable zone start PFN for each node [ 0.000000] Early memory
PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00004000 [ 0.000000] Built
1 zonelists in Zone order, mobility grouping on. Total pages: 16256 [
0.000000] Kernel command line: board=TL-WR1041N-v2 console=ttyS0,115200
rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 256
(order: -2, 1024 bytes) [ 0.000000] Dentry cache hash table entries: 8192
(order: 3, 32768 bytes) [ 0.000000] Inode-cache hash table entries: 4096
(order: 2, 16384 bytes) [ 0.000000] Primary instruction cache 64kB, VIPT,
4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT,
cache aliases, linesize 32 bytes [ 0.000000] Writing ErrCtl
register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [
0.000000] Memory: 61800k/65536k available (2073k kernel code, 3736k reserved,
389k data, 200k init, 0k highmem) [ 0.000000] SLUB: Genslabs=9, HWalign=32,
Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:48 [
0.000000] Calibrating delay loop... 261.73 BogoMIPS (lpj=1308672) [
0.080000] pid_max: default: 32768 minimum: 301 [ 0.080000] Mount-cache hash
table entries: 512 [ 0.090000] NET: Registered protocol family 16 [
0.090000] gpiochip_add: registered GPIOs 0 to 22 on device: ath79 [
0.100000] MIPS: machine is TP-LINK TL-WR1041N v2 [ 0.310000] bio: create
slab at 0 [ 0.320000] Switching to clocksource MIPS [ 0.320000] NET:
Registered protocol family 2 [ 0.330000] IP route cache hash table entries:
1024 (order: 0, 4096 bytes) [ 0.330000] TCP established hash table entries:
2048 (order: 2, 16384 bytes) [ 0.340000] TCP bind hash table entries: 2048
(order: 1, 8192 bytes) [ 0.340000] TCP: Hash tables configured (established
2048 bind 2048) [ 0.350000] TCP reno registered [ 0.350000] UDP hash
table entries: 256 (order: 0, 4096 bytes) [ 0.360000] UDP-Lite hash table
entries: 256 (order: 0, 4096 bytes) [ 0.360000] NET: Registered protocol
family 1 [ 0.390000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [
0.390000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY)
(c) 2001-2006 Red Hat, Inc. [ 0.400000] msgmni has been set to 120 [
0.410000] io scheduler noop registered [ 0.410000] io scheduler deadline
registered (default) [ 0.420000] Serial: 8250/16550 driver, 1 ports, IRQ
sharing disabled [ 0.440000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq =
11) is a 16550A [ 0.450000] console [ttyS0] enabled, bootconsole disabled [
0.450000] console [ttyS0] enabled, bootconsole disabled [ 0.460000] m25p80
spi0.0: found en25q32b, expected m25p80 [ 0.470000] m25p80 spi0.0: en25q32b
(4096 Kbytes) [ 0.480000] 5 tp-link partitions found on MTD device spi0.0 [
0.480000] Creating 5 MTD partitions on "spi0.0": [ 0.490000]
0x000000000000-0x000000020000 : "u-boot" [ 0.490000]
0x000000020000-0x0000000fc3bc : "kernel" [ 0.500000] mtd: partition "kernel"
must either start or end on erase block boundary or be smaller than an erase
block -- forcing read-only [ 0.510000] 0x0000000fc3bc-0x0000003f0000 :
"rootfs" [ 0.520000] mtd: partition "rootfs" must either start or end on
erase block boundary or be smaller than an erase block -- forcing read-only [
0.530000] mtd: partition "rootfs" set to be root filesystem [ 0.540000]
mtd: partition "rootfs_data" created automatically, ofs=2C0000, len=130000 [
0.550000] 0x0000002c0000-0x0000003f0000 : "rootfs_data" [ 0.560000]
0x0000003f0000-0x000000400000 : "art" [ 0.560000]
0x000000020000-0x0000003f0000 : "firmware" [ 0.810000] ag71xx_mdio: probed [
0.930000] ag71xx_mdio: probed [ 0.940000] eth0: Atheros AG71xx at
0xb9000000, irq 4 [ 1.520000] eth0: AR8327 switch driver attached. [
1.650000] ag71xx ag71xx.0: eth0: connected to PHY at ag71xx-mdio.0:00
[uid=004dd033, driver=Atheros AR8216/AR8236/AR8316] [ 1.670000] TCP westwood
registered [ 1.670000] NET: Registered protocol family 17 [ 1.670000]
8021q: 802.1Q VLAN Support v1.8 [ 1.690000] VFS: Mounted root (squashfs
filesystem) readonly on device 31:2. [ 1.690000] Freeing unused kernel
memory: 200k freed - preinit - Press the [f] key and hit [enter] to enter
failsafe mode [ 4.650000] eth0: link up (1000Mbps/Full duplex) - regular
preinit - [ 6.790000] JFFS2 notice: (468) jffs2_build_xattr_subsystem:
complete building xattr subsystem, 1 of xdatum (0 unchecked, 0 orphan) and 24
of xref (0 dead, 15 orphan) found. switching to jffs2 - init - [ 6.940000]
eth0: link down Please press Enter to activate this console. [ 8.330000]
Compat-wireless backport release: compat-wireless-2012-04-17-1-r31481 [
8.340000] Backport based on wireless-testing.git master-2012-04-17 [
8.370000] cfg80211: Calling CRDA to update world regulatory domain [
8.650000] cfg80211: World regulatory domain updated: [ 8.660000] cfg80211:
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [
8.670000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000
mBm) [ 8.670000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300
mBi, 2000 mBm) [ 8.680000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000
KHz), (300 mBi, 2000 mBm) [ 8.690000] cfg80211: (5170000 KHz - 5250000 KHz
@ 40000 KHz), (300 mBi, 2000 mBm) [ 8.700000] cfg80211: (5735000 KHz -
5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 8.810000] usbcore:
registered new interface driver usbfs [ 8.820000] usbcore: registered new
interface driver hub [ 8.820000] usbcore: registered new device driver usb [
9.300000] ieee80211 phy0: Atheros AR9340 Rev:0 mem=0xb8100000, irq=47 [
9.310000] cfg80211: Calling CRDA for country: US [ 9.450000] cfg80211:
Regulatory domain changed to country: US [ 9.450000] cfg80211: (start_freq
- end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 9.460000] cfg80211:
(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) [ 9.470000]
cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) [
9.480000] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000
mBm) [ 9.490000] cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300
mBi, 2000 mBm) [ 9.500000] cfg80211: (5650000 KHz - 5710000 KHz @ 40000
KHz), (300 mBi, 2000 mBm) [ 9.500000] cfg80211: (5735000 KHz - 5835000 KHz
@ 40000 KHz), (300 mBi, 3000 mBm) [ 9.510000] PPP generic driver version
2.4.2 [ 9.560000] ip_tables: (C) 2000-2006 Netfilter Core Team [
9.660000] NET: Registered protocol family 24 [ 9.770000] ehci_hcd: USB 2.0
'Enhanced' Host Controller (EHCI) Driver [ 9.800000] nf_conntrack version
0.5.0 (968 buckets, 3872 max) [ 11.810000] eth0: link up (1000Mbps/Full
duplex) [ 11.930000] device wlan0 entered promiscuous mode [ 14.130000]
device wlan0 left promiscuous mode [ 14.130000] br-lan: port 1(wlan0) entered
disabled state [ 14.330000] device wlan0 entered promiscuous mode [
14.540000] br-lan: port 1(wlan0) entered forwarding state [ 14.550000]
br-lan: port 1(wlan0) entered forwarding state [ 16.400000] device eth0.1
entered promiscuous mode [ 16.410000] device eth0 entered promiscuous mode [
16.410000] br-lan: port 2(eth0.1) entered forwarding state [ 16.420000]
br-lan: port 2(eth0.1) entered forwarding state [ 29.600000] br-lan: port
1(wlan0) entered forwarding state [ 31.440000] br-lan: port 2(eth0.1) entered
forwarding state
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
