On 21 January 2012 00:53, Marco Antonio Mauro <marcu...@gmail.com> wrote: > This patch adds support for the Sitecom WL-341 v3 and other Sercomm > IP1006RRv2 based boards for sysupgrade support and for the initial > flash through pushbutton initiated recovery mode with the special > partition table and fixes for the quirks and things required by the > modified bootloader. > > There are two known bugs: > > 1. The LED configuration is broken -- only one led is working, an > amber led, as I found no way to know which GPIOs were used for those. > The board has 6 unlabeled leds, of which 1 is blue only and 5 are > amber/blue. If I understand which GPIOs go to which leds I'll submit a > patch later.
I had this problem too and wrote a script to test gpios for leds and buttons (see attachment). Hope it'll help you (and maybe someone else). Note that it will not help if your leds are connected via shift registers (as on Belkin boards). > 2. Wi-Fi is not working on my board probably because of the lack of > RAM (the board only has 16MiB ram, but there is an empty slot for > another ram chip,) but I don't know for sure. The driver loads but > hostapd fails to load so I think it's not related to the specific > device except for the lack of RAM. That's very strange, I don't have such problem with my 4/16 MB Sparklan WCR-150GN. I don't quite understand how it could be that it's low RAM problem if all kernel modules are loaded _before_ everything else? Regards, Roman
blinker
Description: Binary data
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
