Hi all,
I am implementing a piggy-back style 2-hop Wifi deployment (2-hop is all we
need, so we don’t need mesh) with two TP-Link 741. What I did is the following:
clientA ---> TPLinkA-TPLinkB ---> clientB
The TPLinkA and TPLinkB are installed with backfire and are configured to run
in AP mode. They are directly connected with an Ethernet cable and are set to
channels 1 and 11 respectively.
After setting it up. I got 30+Mbps from cleintA to TPLinkA and from TPLinkB to
cleintB (using iperf) with both routers switched ON at the same time.
Theoretically, I was hoping to get also 30+MBps from clientA to clientB as
well. However, I only got about 17Mbps and sometimes even as low as 2~3MBps.
Both TPLinkA and TPLinkB are ON in both cases, so the interference seen by both
clients should be the same in both cases.
What could I have done wrong? Any help will be very much appreciated.
Regards,
Robert.
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
