Previously hostapd created one control interface /var/run/hostapd-phyX
which only contained the first virtual bssid (for example wlan0). In
order to access the other virtual bssids with hostapd_cli add all
virtual bssids to /var/run/hostapd-phyX by specifying the ctrl_interface
parameter per bssid.
Previously the control interface looked like:
/var/run/hostapd-phyX/wlan0
Now, the control interface looks like this:
/var/run/hostapd-phyX/wlan0
/var/run/hostapd-phyX/wlan1
...
Signed-off-by: Helmut Schaa <helmut.sc...@googlemail.com>
---
package/hostapd/files/hostapd.sh | 4 +++-
1 files changed, 3 insertions(+), 1 deletions(-)
diff --git a/package/hostapd/files/hostapd.sh b/package/hostapd/files/hostapd.sh
index 7d110db..9e98a1b 100644
--- a/package/hostapd/files/hostapd.sh
+++ b/package/hostapd/files/hostapd.sh
@@ -9,6 +9,9 @@ hostapd_set_bss_options() {
config_get device "$vif" device
config_get hwmode "$device" hwmode
+ config_get phy "$device" phy
+
+ append "$var" "ctrl_interface=/var/run/hostapd-$phy" "$N"
if [ "$ap_isolate" -gt 0 ]; then
append "$var" "ap_isolate=$ap_isolate" "$N"
@@ -184,7 +187,6 @@ hostapd_setup_vif() {
[ "$channel" = auto ] && channel=
[ -n "$channel" -a -z "$hwmode" ] && wifi_fixup_hwmode "$device"
cat > /var/run/hostapd-$ifname.conf <<EOF
-ctrl_interface=/var/run/hostapd-$ifname
driver=$driver
interface=$ifname
${hwmode:+hw_mode=${hwmode#11}}
--
1.7.1
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
