when setting the output state of one GPIO pin we have to keep the state of the
other pins, hence use binary OR. also gpio_direction_output() wants to set an
initial value, so add that too.
this fixes a problem with the USB power switch on mtx-1 boards.
Signed-off-by: Bruno Randolf <[EMAIL PROTECTED]>
---
target/linux/au1000/patches/017-gpio-dir.patch | 20 ++++++++++++++++++++
1 files changed, 20 insertions(+), 0 deletions(-)
create mode 100644 target/linux/au1000/patches/017-gpio-dir.patch
diff --git a/target/linux/au1000/patches/017-gpio-dir.patch
b/target/linux/au1000/patches/017-gpio-dir.patch
new file mode 100644
index 0000000..c499d38
--- /dev/null
+++ b/target/linux/au1000/patches/017-gpio-dir.patch
@@ -0,0 +1,20 @@
+--- linux-2.6.25.16/arch/mips/au1000/common/gpio.c.org 2008-09-04
22:32:12.000000000 +0200
++++ linux-2.6.25.16/arch/mips/au1000/common/gpio.c 2008-09-04
23:10:18.000000000 +0200
+@@ -66,7 +66,8 @@
+ static int au1xxx_gpio2_direction_output(unsigned gpio, int value)
+ {
+ gpio -= AU1XXX_GPIO_BASE;
+- gpio2->dir = (0x01 << gpio) | (value << gpio);
++ gpio2->dir |= 0x01 << gpio;
++ gpio2->output = (GPIO2_OUTPUT_ENABLE_MASK << gpio) | (value << gpio);
+ return 0;
+ }
+
+@@ -95,6 +96,7 @@
+ static int au1xxx_gpio1_direction_output(unsigned gpio, int value)
+ {
+ gpio1->trioutclr = (0x01 & gpio);
++ au1xxx_gpio1_write(gpio, value);
+ return 0;
+ }
+
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
http://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
