Tomasz Chmielewski wrote: > Steve Brown schrieb: >> Tomasz Chmielewski wrote: >>> Stefan Monnier schrieb: >>> >>> (...) >>> >>> >>>>> The b43 driver now loads, loads firmware and returns scan results. >>>>> >>>> With the above patch (and a freshly updated svn checkout of Kamikaze), >>>> my WL700gE indeed loads the driver, it seems to load the firmware as >>>> well, but something goes wrong afterwards and I don't get any network >>>> interface. The corresponding dmesg output is: >>>> >>>> b43-phy0: Broadcom 4318 WLAN found >>>> b43-phy0 debug: Found PHY: Analog 3, Type 2, Revision 7 >>>> b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, >>>> Revision 8 >>>> b43-phy0 debug: DebugFS (CONFIG_DEBUG_FS) not enabled in kernel >>>> config >>>> phy0: Selected rate control algorithm 'pid' >>>> phy0: Failed to initialize wep >>>> b43: probe of ssb1:0 failed with error -12 >>>> Broadcom 43xx driver loaded [ Features: NLR, Firmware-ID: FW13 ] >>>> >>> Same here on WL-500gP. >>> >>> And I don't think firmware is loaded - I have exactly the same >>> output when I don't even have /lib/firmware/b43 directory. >>> >>> >>> >> I cannot reproduce your results. For me, the patch works fine. > > Could you post your kernel .config? > I have posted my kernel config (which is pretty big) and some comments to the thread at http://forum.openwrt.org/viewtopic.php?id=15443&p=1.
I think I've used up my share of this list's bandwidth for a while. Steve _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org http://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
