вт, 23 июн. 2020 г. в 23:17, James Bottomley <
james.bottom...@hansenpartnership.com>:
> On Tue, 2020-06-23 at 21:43 +0500, Илья Шипицин wrote:
> > as far as I understand, openssl-1.0.2 does not support engines ?
>
> No, it does. Engines were a pre 0.9.8 thing. I support openssl in my
> builds for the TPM engine down to 1.0.1
>
> However, the failure:
>
> > Key mismatch not detected
> >
> > FAIL: check_engine_keys.sh
> >
> > ====================================================
> >
> > 1 of 1 test failed
> >
> > Please report to openvpn-us...@lists.sourceforge.net
> >
> > ====================================================
>
> Is because an expected message isn't found in the output. I think it's
> this:
>
> # first off check we died because of a key mismatch. If this doesn't
> # pass, suspect openssl of returning different messages and update the
> # test accordingly
> grep -q 'X509_check_private_key:key values mismatch' log.txt || { echo
> "Key mismatch not detected"; exit 1; }
>
> If I could get hold of log.txt that would confirm that the test is
> outputting something slightly different from what's expected.
>
> I did run this test on openssl-1.0.2j (I keep a copy of
> openSUSE_Leap_42.3 around precisely for this openssl testing) but it
> ran just fine. so there's clearly something different about the 1.0.2u
> you're using (might be a locale issue?).
>
I'll have a look. Also, I think we should out log.txt in case of failure.
>
> James
>
>
_______________________________________________
Openvpn-devel mailing list
Openvpn-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/openvpn-devel
