Hi,
On Thu, Jun 30, 2016 at 11:04 AM, Samuli Seppänen <[email protected]
<mailto:[email protected]>> wrote:
The installer linked to above implement all of the above. However, these
three changes are required for things to work properly:
<https://github.com/OpenVPN/openvpn-build/pull/23>
<https://github.com/xkjyeah/openvpnserv2/pull/7>
Alternatively the startup mode may be changed from the installer using
sc config OpenVPNServiceInteractive start=auto
Yeah, I was planning on using sc.exe for managing Interactive Service.
I've heard sc.exe is available on all of our supported platforms, and
also in a predictable path.
Something like this to change the mode at install time will be required
to support the checkbox mentioned below.
<https://github.com/OpenVPN/openvpn/pull/57>
The only thing missing is launching the "Interactive Service" at install
time, and adding a checkbox "Enable Interactive Service" to the
installer, as agreed upon in this email thread:
Oh I missed this paragraph on the first read -- hence my stupid question
in the previous email.. Anyway, once the startup mode is set as
automatic it will anyway start after next reboot, so is there a need to
have that checkbox? Unless unchecking it also means the mode will be
changed to manual.
The "Enable Interactive Service" checkbox would control the state of the
Interactive service:
Yes -> service mode set to automatic, start at OpenVPN install
No -> service mode set to manual, do not start at OpenVPN install
--
Samuli Seppänen
Community Manager
OpenVPN Technologies, Inc
irc freenode net: mattock
