Hello!
I am trying to setup a new Ocata installation following the official
guide but my instances fail to get a DHCP address.
I am using two physical nodes (1x controller and 1x compute) each one
with two network interfaces.
Compute node can reach the Controller node via the first interface and
vice versa.
As recommended by the manual the second interface is unnumbered.
When I launch an instance I can see using "tcpdump" that the DHCP
request reaches the second (the unnumbered) interface
of the compute node but never reaches any other interface either on
compute or controller node.
Therefore I am wondering how should the instance get an IP address?
What is the correct path that is followed?
I have tried that using both provider and self-service networks and the
result is always the same.
Looking forward for any directions, recommendations etc.
All the best,
G.
_______________________________________________
Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
Post to : openstack@lists.openstack.org
Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
