Basic question same hardware? Inviato da iPhone
> Il giorno 09 mag 2016, alle ore 07:53, Cale Bouscal > <[email protected]> ha scritto: > > We're running Mirantis 8 here, in a lab with a single compute node and > 3 controllers. The compute node is actually a gateway to a vmware node. > (I did not set this up and may not be describing this accurately). > > Problem: We wish to use heat templates to create an auto-scaling group > based on cpu utilization spikes. We've created the templates and tested > them in an RDO setup, with success (that is to say, we're confident > that the templates are set up correctly). However, we're not seeing the > poller pick up the event (the log says "Skip pollster cpu, > no resources found this cycle"). In my functioning RDO setup, I see > this line in the log: "Polling pollster > cpu in the context of cpu_source" > > We've been working with our Mirantis support for about a week with > little to show for it. We've checked the timing settings (making sure > the configured time units are >= polling times in the pipeline.yaml). > > We're not sure where else to look, and I'm hoping the community can > help. > _______________________________________________ > Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack > Post to : [email protected] > Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack > > !DSPAM:1,5730a8ac31376147515729! > _______________________________________________ Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack Post to : [email protected] Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
