http://docs.openstack.org/trunk/config-reference/content/section_compute-hypervisors.html has configuration entries for each hypervisor type.
On Thu, Jun 26, 2014 at 12:06 PM, O'Reilly, Dan <daniel.orei...@dish.com> wrote: > OK. So, next question is the specific configuration for each compute > node. Do you know if there are sample configurations (e.g., nova.conf) > available for these? > > > > Thanks! > > > > *From:* Andrew Mann [mailto:and...@divvycloud.com] > *Sent:* Thursday, June 26, 2014 10:22 AM > *To:* O'Reilly, Dan > *Cc:* openstack@lists.openstack.org > *Subject:* Re: [Openstack] Architectural question > > > > Dan, > > > > If I understand your question properly, you can do this from the Horizon > management web interface as an admin user. Under Admin->System Panel->Host > Aggregates setup 3 aggregates each in their own availability zone, and then > assign each host into a corresponding aggregate. > > > > I don't think the controller node needs any special configuration, and the > compute nodes should just need the configuration to use the specific > hypervisor you want on that host. Each compute node must be running before > it can be added to the host aggregate through the UI. > > > > > > On Thu, Jun 26, 2014 at 10:45 AM, O'Reilly, Dan <daniel.orei...@dish.com> > wrote: > > I’m building a cloud and have a question about architecture/viability. > Right now, I have the following configuration: > > > > - Controller node running RHEL 6.5 > > - Network node running RHEL 6.5 > > - 5 node Ceph cluster for block and object storage > > - 3 compute nodes: > > o 1 running RHEL 6.5 and VMware as the hypervisor > > o 1 running RHEL 6.5 and KVM as the hypervisor > > o 1 running CentOS 6.5 and Xen as the hypervisor > > > > The basic question is on the compute nodes. I’m doing 3 different > hypervisors to do a best-of-breed study (each will be in its own > availability zone). Hence, one of each type. But is it even possible to > have 3 compute nodes like this, and if so, how do I configure the compute > software that runs on the controller node to handle this; and how do I > configure each of the 3 compute nodes as well? > > > > Dan O'Reilly > > UNIX Systems Administration > > [image: cid:638154011@09122011-048B] > > 9601 S. Meridian Blvd. > > Englewood, CO 80112 > > 720-514-6293 > > > > > > > _______________________________________________ > Mailing list: > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack > Post to : openstack@lists.openstack.org > Unsubscribe : > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack > > > > > > -- > > Andrew Mann > > DivvyCloud Inc. > > www.divvycloud.com > -- Andrew Mann DivvyCloud Inc. www.divvycloud.com
_______________________________________________ Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack Post to : openstack@lists.openstack.org Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
