On Sun, 2 Feb 2014 20:08:02 -0800 Adam Lawson <[email protected]> wrote:
> (http://docs.openstack.org/developer/swift/howto_installmultinode.html) > > I'm running into issues where the instructions start to get really > hazy/unclear after step #4 in Configure Proxy Server. Woops, there was a bug in numbering of steps :-) https://review.openstack.org/71051 > It says in step #5 to > run a series of commands for each device listed in "/srv/node" but I > haven't seen a step prior to step #5 that populates that directory with > devices. Well it's not important if the directory is already populated. The docs actually mean the real devices you plan to use -- on each node, not just on proxy. > Thoughts? You should already know what nodes have what devices. Note that device namspace is flat. So, write something like this on a piece of paper: NODE device zone Remark vm1 vm1 is proxy, has no devices vm2 xdb 1 vm2 xdc 2 vm3 xdb 3 vm3 xdc unused, just because vm4 xdb 4 vm4 xdc 5 If you want to stuff them under /var/Monsoon, that's up to you. Note, however, that utilities that have to guess where you hide your devices may not work completely in such case (see swift-get-nodes). You could get better advice by asking on openstack-operators list. -- P _______________________________________________ Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack Post to : [email protected] Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
