Wang,
I guess you are referring to to the instance specific XML file under
/etc/libvirt/qemu. It has the following section having 'vda':
===========================
<devices>
<emulator>/usr/bin/kvm</emulator>
<disk type='file' device='disk'>
<driver name='qemu' type='qcow2' cache='none'/>
<source
file='/var/lib/nova/instances/a562a6c9-9253-4f22-8076-344e855f713d/disk'/>
<target dev='vda' bus='virtio'/>
<address type='pci' domain='0x0000' bus='0x00' slot='0x04'
function='0x0'/>
</disk>
....
===========================
Can you specify what exactly I need to change ?
Thanks,
Nikhil
On Tue, May 14, 2013 at 1:45 PM, Wangpan <hzwang...@corp.netease.com> wrote:
> **
> seems like the roog disk is not a bootable device, you may need to check
> the vda/xvda device in libvirt XML config file is bootable or not.
>
> 2013-05-14
> ------------------------------
> Wangpan
> ------------------------------
> *发件人：*Nikhil Mittal
> *发送时间：*2013-05-14 15:59
> *主题：*[Openstack] [OPENSTACK] VMs don't start on host machine reboot
> (Grizzly over Ubuntu 13.04)
> *收件人：*"openstack"<openstack@lists.launchpad.net>
> *抄送：*
>
> Hello,
> I recently installed Grizzly (single-node) on Ubuntu 13.04 on x86 64 bit
> having two physical NICs. I posted about the networking issues that I was
> facing after the installation in an earlier post.
> Well, while I was debugging the networking issue, I came across a more
> serious issue -- my host machine got rebooted (power-cycle) and on reboot I
> see that my two VMs are shown in "shut-off" Status and "shut-down" Power
> state in the Dashboard GUI. The options available to me are only "soft
> reboot", "hard reboot", "terminate instance", "Disassociate Floating IP"
> and "Edit Instance". I did first "soft reboot" and the console shows "No
> bootable device". Then i tried "Hard reboot" and again the same message "No
> bootable device".
> I checked that all services are running fine and there are no error
> messages in the logs for nova, quantum, etc.
>
> I followed installation instructions based on the following link:
>
> https://github.com/mseknibilel/OpenStack-Grizzly-Install-Guide/blob/OVS_SingleNode/OpenStack_Grizzly_Install_Guide.rst
>
> Thanks,
> Nikhil
>
>
_______________________________________________
Mailing list: https://launchpad.net/~openstack
Post to : openstack@lists.launchpad.net
Unsubscribe : https://launchpad.net/~openstack
More help : https://help.launchpad.net/ListHelp
