On 25/06/14 10:59, Rob Crittenden wrote:
Before I get punted onto the operators list, I post this here because
this is the default config and I'd expect the defaults to just work.
Running devstack inside a VM with a single NIC configured and this in
localrc:
disable_service n-net
enable_service q-svc
enable_service q-agt
enable_service q-dhcp
enable_service q-l3
enable_service q-meta
enable_service neutron
Q_USE_DEBUG_COMMAND=True
Results in a successful install but no DHCP address assigned to hosts I
launch and other oddities like no CIDR in nova net-list output.
Is this still the default way to set things up for single node? It is
according to https://wiki.openstack.org/wiki/NeutronDevstack
That does look ok: I have an essentially equivalent local.conf:
...
ENABLED_SERVICES+=,-n-net
ENABLED_SERVICES+=,q-svc,q-agt,q-dhcp,q-l3,q-meta,q-metering,tempest
I don't have 'neutron' specifically enabled... not sure if/why that
might make any difference tho. However instance launching and ip address
assignment seem to work ok.
However I *have* seen the issue of instances not getting ip addresses in
single host setups, and it is often due to use of virt io with bridges
(with is the default I think). Try:
nova.conf:
...
libvirt_use_virtio_for_bridges=False
Regards
Mark
_______________________________________________
OpenStack-dev mailing list
OpenStack-dev@lists.openstack.org
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
