Continued with ConfigParser, nothing much difference apart from clean way of maintaining INI file in iniparse. I think unless a solution is thought, good to go with this.
Thanks again John. On Mon, Jan 20, 2014 at 11:47 PM, John Griffith <john.griff...@solidfire.com > wrote: > On Mon, Jan 20, 2014 at 11:15 AM, John Griffith > <john.griff...@solidfire.com> wrote: > > On Mon, Jan 20, 2014 at 10:30 AM, iKhan <ik.ibadk...@gmail.com> wrote: > >> Thanks John, > >> > >> It worked earlier while executing because iniparse was installed, tho > this > >> wasn't present in virtual environment. Installing iniparse via pip did > work. > >> Since I didn't install iniparse specifically, I was under impression it > was > >> there by default. Probably now I have to take care of this in > >> test-requirement.txt as you mentioned. > >> > >> I wonder if there is an alternative to iniparse by default. > >> > >> Regards > >> > >> > >> On Mon, Jan 20, 2014 at 10:47 PM, John Griffith > >> <john.griff...@solidfire.com> wrote: > >>> > >>> On Mon, Jan 20, 2014 at 10:07 AM, iKhan <ik.ibadk...@gmail.com> wrote: > >>> > Hi, > >>> > > >>> > I have imported iniparse to my cinder code, it works fine when I > perform > >>> > execution. But when I run the unit test, it fails while importing > >>> > iniparse. > >>> > It says "No module named iniparse". Do I have to take care of > something > >>> > here? > >>> > > >>> > -- > >>> > Thanks, > >>> > Ibad Khan > >>> > 9686594607 > >>> > > >>> > _______________________________________________ > >>> > OpenStack-dev mailing list > >>> > OpenStack-dev@lists.openstack.org > >>> > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev > >>> > > >>> > >>> It sounds like it's not installed on your system. You'd need to do a > >>> "pip install iniparse", but if you're adding this to your unit tests > >>> you'll need to have a look at the common test-requires file. Also > >>> keep in mind if your driver is going to rely on it you'll need it in > >>> requirements. We can work through the details via IRC if you like. > >>> > >>> John > >>> > >>> _______________________________________________ > >>> OpenStack-dev mailing list > >>> OpenStack-dev@lists.openstack.org > >>> http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev > >> > >> > >> > >> > >> -- > >> Thanks, > >> Ibad Khan > >> 9686594607 > >> > >> _______________________________________________ > >> OpenStack-dev mailing list > >> OpenStack-dev@lists.openstack.org > >> http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev > >> > > > > there is check out openstack.common.iniparser, not sure if it'll fit > > your needs or not. > DOH!! Disregard that > > _______________________________________________ > OpenStack-dev mailing list > OpenStack-dev@lists.openstack.org > http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev > -- Thanks, Ibad Khan 9686594607
_______________________________________________ OpenStack-dev mailing list OpenStack-dev@lists.openstack.org http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack-dev
