Hello,
you can try to use the offset parameter (flash bank address):
flash write_image <image> 0x08000000
Regards,
Mathias
On 15.12.2011 01:31, Damjan Marion wrote:
>
> Hi,
>
> I tried to flash STM32 F2 in the same way like i do on F1 devices and hit
> some issues:
>
> My 1st try was with "stm32f2x mass_erase 0" but seems that there is no
> subcommands registered.
>
> Help lists:
>
> stm32f2x
> stm32f2x flash command group (command valid any time)
>
> stm32f2x.c:
>
> static const struct command_registration stm32x_exec_command_handlers[] = {
> COMMAND_REGISTRATION_DONE
> };
>
> When I try to use "flash write_image erase FILE" i got:
>
>> flash write_image erase hello.bin
> auto erase enabled
> wrote 0 bytes from file hello.bin in 0.000433s (0.000 KiB/s)
>
> Is this expected behavior or I'm hitting some specific issue?
>
> Thanks,
>
> Damjan
>
>
>
> _______________________________________________
> Openocd-development mailing list
> [email protected]
> https://lists.berlios.de/mailman/listinfo/openocd-development
_______________________________________________
Openocd-development mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/openocd-development
