Hi,
We would like to add the configuration file for the stm32f2xxx to the GIT
repository.
Here is the file (should be named openocd/tcl/target/stm32f2xxx.cfg )
Thanks for adding this file.
Laurent
--------------
# script for stm32f2xxx
if { [info exists CHIPNAME] } {
set _CHIPNAME $CHIPNAME
} else {
set _CHIPNAME stm32f2xxx
}
if { [info exists ENDIAN] } {
set _ENDIAN $ENDIAN
} else {
set _ENDIAN little
}
# Work-area is a space in RAM used for flash programming
# By default use 128kB
if { [info exists WORKAREASIZE] } {
set _WORKAREASIZE $WORKAREASIZE
} else {
set _WORKAREASIZE 0x20000
}
# JTAG speed should be <= F_CPU/6. F_CPU after reset is 8MHz, so use F_JTAG =
1MHz
jtag_khz 1000
jtag_nsrst_delay 100
jtag_ntrst_delay 100
#jtag scan chain
if { [info exists CPUTAPID ] } {
set _CPUTAPID $CPUTAPID
} else {
# See STM Document RM0033
# Section 32.6.3 - corresponds to Cortex-M3 r2p0
set _CPUTAPID 0x4ba00477
}
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id
$_CPUTAPID
if { [info exists BSTAPID ] } {
set _BSTAPID $BSTAPID
} else {
# See STM Document RM0033
# Section 32.6.2
#
set _BSTAPID 0x06411041
}
jtag newtap $_CHIPNAME bs -irlen 5 -expected-id $_BSTAPID
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m3 -endian $_ENDIAN -chain-position
$_TARGETNAME
$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size
$_WORKAREASIZE -work-area-backup 0
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME stm32f2xxx 0 0 0 0 $_TARGETNAME
# For more information about the configuration files, take a look at:
# openocd.texi
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
