hi ALL: From code : +/* We use the maximal value observed */ +#define JLINK_TAP_BUFFER_SIZE 390 + +static int tap_length; +static u8 tms_buffer[JLINK_TAP_BUFFER_SIZE]; +static u8 tdi_buffer[JLINK_TAP_BUFFER_SIZE]; +static u8 tdo_buffer[JLINK_TAP_BUFFER_SIZE]; +
Does it means SAMPLE op will failed when CellNum is larger than 390? Best Regards 2010-02-03 jerry_xjtu 发件人： jerry_xjtu 发送时间： 2010-02-03 11:20:16 收件人： openocd-development 抄送： 主题： For JLink Support hi ALL: I am using a WIGGLER board to program flash by using boundary scan. It's too slow as here are 734 CellNum on the chip MPC8247, and the TCK is only about 100KHz to 200KHz. I found JLink can works at 12MHz TCK. So my question is: Can we take full control of JLink by using OpenOCD and generate the simulate timing for Flash program?(using boundary scan) Thanks & Best Regards Jerry
_______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
