hi ALL: I am using a WIGGLER board to program flash by using boundary scan. It's too slow as here are 734 CellNum on the chip MPC8247, and the TCK is only about 100KHz to 200KHz. I found JLink can works at 12MHz TCK.
So my question is: Can we take full control of JLink by using OpenOCD and generate the simulate timing for Flash program?(using boundary scan) Thanks & Best Regards Jerry
_______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
