I already tried that: $ telnet localhost 4444 Trying ::1... Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. Open On-Chip Debugger > reset halt RCLK not supported - fallback to 1000 kHz JTAG scan chain interrogation failed: all ones Check JTAG interface, timings, target power, etc. error: -100 Command handler execution failed in procedure 'reset' called at file "command.c", line 637 called at file "command.c", line 352 >
Its like I've got the jtag connector connected wrong. I'm using the beagle board adapter that I got from tincantools. And I have all the pin 1s matched up. On Tue, Dec 1, 2009 at 1:41 PM, David Brownell <davi...@pacbell.net> wrote: > On Tuesday 01 December 2009, John Rigby wrote: >> I'm trying to use OpenOCD with a Flyswatter and a beagleboard and I get this: >> >> # openocd -f ./tcl/interface/flyswatter.cfg -f ./tcl/board/ti_beagleboard.cfg >> Open On-Chip Debugger 0.4.0-dev-00740-ga65e75e (2009-12-01-12:05) >> For bug reports, read >> http://openocd.berlios.de/doc/doxygen/bugs.html >> RCLK - adaptive >> Warn : omap3530.dsp: huge IR length 38 >> RCLK - adaptive >> trst_only separate trst_push_pull >> Info : RCLK (adaptive clock speed) not supported - fallback to 1000 kHz >> Error: JTAG scan chain interrogation failed: all ones >> Error: Check JTAG interface, timings, target power, etc. >> Error: JTAG scan chain interrogation failed: all ones >> Error: Check JTAG interface, timings, target power, etc. >> >> Any ideas? > > "reset halt" should make things work OK. > > I don't know what causes that startup glitch, but things seem to > behave OK after an explicit reset. > > > _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
