This file allows programming of this chip. In fact it can be done via xsvf without even defining a tap, but only if it is the only device in the chain. This tap config is needed when it is in a chain.
Please stick this file in targets. (I get the impression very few people are using openocd for cpld programming because there is much breakage - more about that in later mails) -------xilinx-xcr3256.cfg----- #xilinx coolrunner xcr3256 #simple device - just configure a tap jtag newtap xcr tap -irlen 5 -ircapture 0x01 -irmask 0x1f -expected-id 0x0494c093 ------------------------------- Wookey -- Principal hats: iEndian - Balloonboard - Toby Churchill - Emdebian http://wookware.org/ _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
