Use jtag_rclk instead of jtag_speed. This fixes message
OLD SYNTAX: DEPRECATED - use jtag_khz, not jtag_speed for BeagleBoard.
Subject: [PATCH v3] Use jtag_rclk instead of jtag_speed for BeagleBoard From: Dirk Behme <dirk.be...@googlemail.com> Use jtag_rclk instead of jtag_speed. This fixes message OLD SYNTAX: DEPRECATED - use jtag_khz, not jtag_speed for BeagleBoard. Signed-off-by: Dirk Behme <dirk.be...@googlemail.com> --- Changes in v3: Add default fall back freqency. Tested with Flyswatter and BeagleBoard: RCLK - adaptive ... Info : RCLK (adaptive clock speed) not supported - fallback to 6000 kHz Changes in v2: Don't use jtag_khz, instead use jtag_rclk. Do this in board config file. tcl/board/ti_beagleboard.cfg | 3 +++ tcl/interface/flyswatter.cfg | 2 -- 2 files changed, 3 insertions(+), 2 deletions(-) Index: trunk/tcl/interface/flyswatter.cfg =================================================================== --- trunk.orig/tcl/interface/flyswatter.cfg +++ trunk/tcl/interface/flyswatter.cfg @@ -8,5 +8,3 @@ interface ft2232 ft2232_device_desc "Flyswatter" ft2232_layout "flyswatter" ft2232_vid_pid 0x0403 0x6010 -jtag_speed 1 - Index: trunk/tcl/board/ti_beagleboard.cfg =================================================================== --- trunk.orig/tcl/board/ti_beagleboard.cfg +++ trunk/tcl/board/ti_beagleboard.cfg @@ -1,6 +1,9 @@ # OMAP3 BeagleBoard # http://beagleboard.org +# Fall back to 6MHz if RTCK is not supported +jtag_rclk 6000 + source [find target/omap3530.cfg] # TI-14 JTAG connector
_______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
