On Sat, Aug 22, 2009 at 11:22 PM, michal smulski<michal.smul...@ooma.com> wrote: > I got it working with jtag_khz 10 command. It seems that when C100 runs > at 24MHz, default JTAG speed is too fast. > > I have another question. > When JTAG dongle (I use Olimex) first connects to the board it asserts > srst signal even before jtag chain scan. Is there a way to turn it off. > I would like to be able to connect to the target to see its state. The > only way I can do this now is by disconnecting srst from board reset.
OpenOCD supports some hotplugging, but I would expect the target state to change when you connect the JTAG debugger. I recommend buying an extra interface and keep it connected rather than try to hotplug to that extent. > Also, is there a way to set how long the srst is kept asserted? Typical scope food. -- Øyvind Harboe Embedded software and hardware consulting services http://www.zylin.com _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
