On Mon, Jul 6, 2009 at 9:06 PM, Dominic<dominic.r...@gmx.de> wrote: > On Monday 06 July 2009 20:19:54 Øyvind Harboe wrote: >> On Mon, Jul 6, 2009 at 7:06 PM, Dominic<dominic.r...@gmx.de> wrote: >> > On Monday 06 July 2009 16:57:24 Øyvind Harboe wrote: >> >> On Mon, Jul 6, 2009 at 4:25 PM, Dominic Rath<dominic.r...@gmx.de> >> >> wrote: >> >> > I can run some tests later today when I get home (~2 hours from now). >> >> > I have a arm926ejs board. >> >> >> >> That would be great! >> >> >> >> It would be especially helpful if you could also read over >> >> arm926ejs.c/arm926ejs_examine_debug_reason() w.r.t. interpretation >> >> of unknown/undocumented MOE values. >> > >> > Any examples of sequences that should fail? >> >> I get MOE=0xe upon "reset run" of i.MX27. > > "reset run" works just fine here, but "reset halt" fails, and only a power > cycle gets the target in a cooperative state after this. The target halt > times out, and JTAG communication is obviously broken afterwards. Halting > isn't possible, and I get a bogus debug reason (MOE) 0xf.
MOE=0xf would be a result of receiving all '1's.... Any chance of a bisection on when this broke? -- Øyvind Harboe Embedded software and hardware consulting services http://www.zylin.com _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
