Fix for a goofy "board" config ... reuse target/pxa270.cfg
instead of using a private copy.
---
tcl/board/crossbow_tech_imote2.cfg | 44 +++--------------------------------
1 file changed, 4 insertions(+), 40 deletions(-)
Fix for a goofy "board" config ... reuse target/pxa270.cfg
instead of using a private copy.
---
tcl/board/crossbow_tech_imote2.cfg | 44 +++--------------------------------
1 file changed, 4 insertions(+), 40 deletions(-)
--- a/tcl/board/crossbow_tech_imote2.cfg
+++ b/tcl/board/crossbow_tech_imote2.cfg
@@ -1,46 +1,10 @@
# Crossbow Technology iMote2
-if { [info exists CHIPNAME] } {
- set _CHIPNAME $CHIPNAME
-} else {
- set _CHIPNAME imote2
-}
-
-if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
-} else {
- set _ENDIAN little
-}
-
-if { [info exists CPUTAPID ] } {
- set _CPUTAPID $CPUTAPID
-} else {
- # force an error till we get a good number
- set _CPUTAPID 0xffffffff
-}
+set CHIPNAME imote2
+source [find target/pxa270.cfg]
-# PXA271 and an Intel Strataflash of 32 Megabytes (p30)
-#
-# Marvell/Intel PXA270 Script
-# set jtag_nsrst_delay to the delay introduced by your reset circuit
-# the rest of the needed delays are built into the openocd program
+# longer-than-normal reset delay
jtag_nsrst_delay 800
-# set the jtag_ntrst_delay to the delay introduced by a reset circuit
-# the rest of the needed delays are built into the openocd program
-jtag_ntrst_delay 0
-#use combined on interfaces or targets that can't set TRST/SRST separately
-reset_config trst_and_srst separate
-#jtag scan chain
-
-jtag newtap $_CHIPNAME cpu -irlen 7 -ircapture 0x1 -irmask 0x7f -expected-id $_CPUTAPID
-set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
-target create $_TARGETNAME xscale -endian $_ENDIAN -chain-position $_TARGETNAME -variant pxa27x
-$_TARGETNAME configure -work-area-virt 0x0x5c000000 -work-area-phys 0x0x5c000000 -work-area-size 0x10000 -work-area-backup 1
-# maps to PXA internal RAM. If you are using a PXA255
-# you must initialize SDRAM or leave this option off
-
-
-#flash bank <driver> <base> <size> <chip_width> <bus_width>
# works for P30 flash
-flash bank cfi 0x00000000 0x2000000 2 2 0
+flash bank cfi 0x00000000 0x2000000 2 2 $_TARGETNAME
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
