On Tue, May 19, 2009 at 10:36 PM, Xiaofan Chen <xiaof...@gmail.com> wrote: > Now I see the same behavior of my black J-Link. This is even > after adding part of the patch from Magnus to correct the endpoint. > Once the LED goes off after running openocd, run Segger's > utility and you will know that it is out of sync. So there are > still some problems. The only way to recover seems to disconnect > everything and restart again. >
Now if I compare V6 to V3 based on some simple test, it seems my V6 works (no problem with halt target and single step) and my V3 does not (can not halt target and step). I believe your version is similar to my V3 and with even older firmware. -- Xiaofan http://mcuee.blogspot.com _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
