Attached is a LPC2124 config file. Hope it helps!
Cheers,
Jesus Sanchez-Palencia
Index: src/target/target/lpc2124.cfg
===================================================================
--- src/target/target/lpc2124.cfg (revision 0)
+++ src/target/target/lpc2124.cfg (revision 0)
@@ -0,0 +1,38 @@
+#LPC-2124 CPU
+
+if { [info exists CHIPNAME] } {
+ set _CHIPNAME $CHIPNAME
+} else {
+ set _CHIPNAME lpc2124
+}
+
+if { [info exists ENDIAN] } {
+ set _ENDIAN $ENDIAN
+} else {
+ set _ENDIAN little
+}
+
+if { [info exists CPUTAPID ] } {
+ set _CPUTAPID $CPUTAPID
+} else {
+ # force an error till we get a good number
+ set _CPUTAPID 0x4f1f0f0f
+}
+
+
+#use combined on interfaces or targets that can't set TRST/SRST separately
+reset_config trst_and_srst srst_pulls_trst
+jtag_nsrst_delay 10
+jtag_khz 1000
+
+#jtag scan chain
+jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+
+set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
+target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
+
+$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
+
+
+#flash bank <driver> <base> <size> <chip_width> <bus_width>
+flash bank lpc2000 0x0 0x40000 0 0 0 lpc2000_v1 14745 calc_checksum
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
