Hi,
here is a small patch to add some documentation for the mips_m4k target
options.
I've also added the arm11 target to the targets list to bring the list
up to date wrt trunk. (but no options docs since I don't know that
target).
Cheers,
John McCarthy.
Index: doc/openocd.texi
===================================================================
--- doc/openocd.texi (revision 1132)
+++ doc/openocd.texi (working copy)
@@ -576,11 +576,13 @@
@item @b{cortex_m3}
@item @b{feroceon}
@item @b{xscale}
[EMAIL PROTECTED] @b{arm11}
@item @b{mips_m4k}
@end itemize
If you want to use a target board that is not on this list, see Adding a new
-target board
+target board.
+The @option{target types} command can be used to get the list of targets supported from within openocd.
Endianess may be @option{little} or @option{big}.
@@ -638,6 +640,16 @@
Supported variants are @option{ixp42x}, @option{ixp45x}, @option{ixp46x},
@option{pxa250}, @option{pxa255}, @option{pxa26x}.
[EMAIL PROTECTED] arm11 options
[EMAIL PROTECTED] arm11 options
+
[EMAIL PROTECTED] mips_m4k options
[EMAIL PROTECTED] mips_m4k options
+Use variant @option{ejtag_srst} when debugging targets that
+do not provide a functional SRST line on the EJTAG connector.
+This causes openocd to instead use an EJTAG software reset command to reset the processor.
+You still need to enable @option{srst} on the reset configuration command to enable openocd hardware reset functionality.
+
@section Flash configuration
@cindex Flash configuration
_______________________________________________
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-development
