I started a 400+ GB send to a USB HD on s10_u8. Next morning the desktop was hung and nothing would wake it, so I forced it down. The send apparently had not finished as an attempt to read it on the Z840 showed.
So I deleted the partial stream and started over. This morning same situation. This system has been reliably running for years. But I've never done that large a send to a USB device. Console is through a 4 way KVM switch. The other ports still are fine, but the s10_u8 says "no signal" on the monitor. There is NO way in except the console. This is by design. Because of its age it's locked down hard. I know that it will reboot fine, but it appears that USB speed had dropped to a very low data rate. I estimated an 8-10 hour transfer time. I'm now near twice that. I can reboot and transfer the volume in smaller pieces, but I'm very curious as I've never seen this in 14 years of the system running on minor variations of the same hardware. Why would the console desktop hang? Suggestions? Will a zfs send resume after a power loss? That seems to be the only way to recover access. Thanks, Reg _______________________________________________ openindiana-discuss mailing list openindiana-discuss@openindiana.org https://openindiana.org/mailman/listinfo/openindiana-discuss
