On 4/11/11 7:42 PM, carlopmart wrote:
On 11/04/2011 02:32 AM, Peter Lees wrote:
hi folks
i'm trying to run openindiana 151a in a VM using KVM linux (centos 6.0)
i'm trying to use a bridged ethernet connection, but for some reason the
data is not getting through (can't ping the real network)
this is probably more a centos/linux question than OI, but i wondered if
anyone had a similar setup they could share ?
regards
p
--
peter lees
How do you defined the bridge in c6 host?? What nic driver do you use in
OI??
centos6 (host) bridge is defined using /etc/sysconfig/network-scripts:
ifcfg-eth0:
DEVICE="eth0"
BRIDGE=br0
NM_CONTROLLED="no"
ONBOOT="yes"
HWADDR=00:1E:67:14:E7:5D
TYPE=Ethernet
DNS1=10.16.168.10
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
ifcfg-br0
DEVICE=br0
NM_CONTROLLED=no
BOOTPROTO=static
ONBOOT=yes
TYPE=Bridge
IPADDR=10.16.168.3
PREFIX=27
GATEWAY=10.16.168.10
DNS1=10.16.168.10
DEFROUTE=yes
IPV6INIT=no
10.16.168.3 is the host IP address on that network.
nics driver on OI was the default rtl8139 (rtls0), but i have changed to
e1000g (the physical port, fwiw, is e1000g)
both types plumb OK on the OI VM, but no traffic seems to cross the bridge
thoughts?
p
_______________________________________________
OpenIndiana-discuss mailing list
OpenIndiana-discuss@openindiana.org
http://openindiana.org/mailman/listinfo/openindiana-discuss
