On 23 November 2016 at 15:29, Nathan Rossi <nat...@nathanrossi.com> wrote: > Just pinging these patches, to see if there were any issues or > comments. I realize I sent them just before a release so it was very > likely they would get lost in the noise.
Pinging these three patches again. https://patchwork.openembedded.org/patch/133134/ https://patchwork.openembedded.org/patch/133135/ (another patch was just sent by someone else which does the same change, https://lists.yoctoproject.org/pipermail/yocto/2017-January/033840.html) And I've updated the third one, sent a v2 so that it applies cleanly to master. https://patchwork.openembedded.org/patch/135805/ Thanks, Nathan > > Thanks, > Nathan > > On 21 October 2016 at 22:07, Nathan Rossi <nat...@nathanrossi.com> wrote: >> Allow the load and entry addresses to remain unset if the UBOOT_RD_* >> variables are also unset for ramdisk entries in the image tree. This >> allows for U-Boot to decide dynamically where to load the ramdisk. >> >> Signed-off-by: Nathan Rossi <nat...@nathanrossi.com> >> --- >> meta/classes/kernel-fitimage.bbclass | 13 +++++++++++-- >> 1 file changed, 11 insertions(+), 2 deletions(-) >> >> diff --git a/meta/classes/kernel-fitimage.bbclass >> b/meta/classes/kernel-fitimage.bbclass >> index 3bbf91f65a..5c9e76b9ac 100644 >> --- a/meta/classes/kernel-fitimage.bbclass >> +++ b/meta/classes/kernel-fitimage.bbclass >> @@ -178,6 +178,15 @@ EOF >> fitimage_emit_section_ramdisk() { >> >> ramdisk_csum="sha1" >> + ramdisk_loadline="" >> + ramdisk_entryline="" >> + >> + if [ -n "${UBOOT_RD_LOADADDRESS}" ]; then >> + ramdisk_loadline="load = <${UBOOT_RD_LOADADDRESS}>;" >> + fi >> + if [ -n "${UBOOT_RD_ENTRYPOINT}" ]; then >> + ramdisk_entryline="entry = <${UBOOT_RD_ENTRYPOINT}>;" >> + fi >> >> cat << EOF >> ${1} >> ramdisk@${2} { >> @@ -187,8 +196,8 @@ fitimage_emit_section_ramdisk() { >> arch = "${UBOOT_ARCH}"; >> os = "linux"; >> compression = "none"; >> - load = <${UBOOT_RD_LOADADDRESS}>; >> - entry = <${UBOOT_RD_ENTRYPOINT}>; >> + ${ramdisk_loadline} >> + ${ramdisk_entryline} >> hash@1 { >> algo = "${ramdisk_csum}"; >> }; >> -- >> 2.9.3 -- _______________________________________________ Openembedded-core mailing list Openembedded-core@lists.openembedded.org http://lists.openembedded.org/mailman/listinfo/openembedded-core
