On 02/14/13 15:57, Jack Mitchell wrote:
On 14/02/13 15:44, Jack Mitchell wrote:
On 14/02/13 15:31, Burton, Ross wrote:
On 14 February 2013 14:31, Jack Mitchell <m...@communistcode.co.uk>
wrote:
Did this ever go anywhere? I have just tried again today with
exactly the
same result, all I did was change the DISTRO_FEATURES_INITMAN to
systemd.
Odd, as I just built and booted a systemd image (core-image-sato, in
poky master), and it worked fine.
Ross
I have a custom distro definition that cuts a lot of features out.
Can you find out which package is supposed to create run and I can
check if it is pulled in properly on my setup?
I think something must be assumed somewhere and I don't have the
features enabled to trigger it.
From a quick look it seems as though volatiles in initscripts-1.0
should create the run directory if it's not found. However the
initscripts package doesn't get pulled in on my image at all, and I
can't see an equivalent in the systemd package
Doing a manual ln -s var/run run on my mounted SD card gets systemd to
the first [OK] part but then the board dies on me, it's a usb ftdi
serial and even that connection gets wiped. I think there is something
fundamentally wrong somewhere, which is causing the systemd setup to not
execute properly, or the fact that there are minimal packages and
minimal features in my distro image is causing the problem.
What I will maybe try to do tomorrow is build a stock core-image-minimal
with systemd, then remove distro features one by one and see if it breaks.
_______________________________________________
Openembedded-core mailing list
Openembedded-core@lists.openembedded.org
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-core
