On Tue, Aug 9, 2011 at 2:42 PM, Jason Kridner <jkrid...@beagleboard.org> wrote: > On Tue, Aug 9, 2011 at 2:59 PM, Joel A Fernandes <agnel.j...@gmail.com> wrote: >> Just posted this on the systemd mailing list. > > Are these the right lists on this thread? Just not sure if some folks > on the CC might consider this too off-topic. > >> >> It seems that I didn't go through enough testing on the >> systemd-gnome-image built by OE. The success I reported with boot SD >> card instead of over NFS was just a got-lucky case. So SD Card and NFS >> alike, the boot still hangs. >> >> Koen and others, could you try my image? >> http://www.beagleboard.org/~joelf/images/Angstrom-systemd-GNOME-image-eglibc-ipk-v2011.08-core-beagleboard.rootfs.tar.bz2 > > Can you provide an SD card image as well? Running mkcard.txt or > linaro-create-image is often error prone and time consuming.
Could you untar the file I uploaded into the FS partition? You could use the image from here: http://circuitco.com/support/files/BeagleboardxM/xMc_4_25.zip >>> [..] >>> Starting Login Service... >>> Starting Permit User Sessions... >>> Started Permit User Sessions. >>> Starting ntpd: Started Console System Startup Logging. >>> Started D-Bus System Message Bus. >>> Starting internet superserver: xinetd. >>> [ 5.773284] ntpd[137]: ntpd 4.2.6p3@1.2290 Fri Jul 29 17:35:18 UTC 2011 >>> (2) >>> done >>> [ 5.809906] ntpd[154]: proto: precision = 30.517 usec >>> [ 5.829437] ntpd[154]: Listen and drop on 0 v4wildcard 0.0.0.0 UDP 123 >>> [ 5.849182] xinetd[156]: 156 {init_services} no services. Exiting... >>> [ 5.864044] ntpd[154]: Listen and drop on 1 v6wildcard :: UDP 123 >>> [ 5.882141] ntpd[154]: Listen normally on 2 lo 127.0.0.1 UDP 123 >>> [ 5.906188] ntpd[154]: Listen normally on 3 lo ::1 UDP 123 >>> [ 5.935424] ntpd[154]: peers refreshed >>> [ 5.939361] ntpd[154]: Deferring DNS for pool.ntp.org 1 >>> [ 6.385498] twl_rtc twl_rtc: rtc core: registered twl_rtc as rtc0 >>> [ 7.948211] ntpd_intres[162]: host name not found: pool.ntp.org > > How long did you wait here for a timeout of some kind? What happens > here different when it works? Did you try SysRq? What is the state > of the board and native console? I waited for 15 minutes. The MMC card LED doesn't glow indicating no activity. The console has hung with the messages above. I tried sysrq but there is no response. CONFIG_MAGIC_SYSRQ=y in my .config Thanks, Joel _______________________________________________ Openembedded-core mailing list Openembedded-core@lists.openembedded.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-core
