On Aug 5, 2015, at 3:33 PM, Frank Fegert <[email protected]> wrote:
> achieved with the "iscsiadm -m fw [...]" or a similar command. You want the iscsiadm host flashnode mode, and I think the setting is the iface mtu one. I do not have a qlogic card handy, but I think the command would be something like: iscsiadm -m $host_number -C flashnode -A ipv4 -x flashnode_index -o update -n iface.mtu -v 8192 for 8192 replace with whatever frame size you wanted that the card supports. For -A the possible settings are ipv4 or ipv6. For the -X flashnode_index setting then you do iscsiadm -m host_number -C flashnode This will print out the targets stored in the card. The number after qla4xxx will be the index of each entry in flash that you would use for -x. I think there is also a way to set it as the default for all targets on a host/iface by using the iscsiadm -m iface mode, but I cannot remember. -- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/open-iscsi. For more options, visit https://groups.google.com/d/optout.
