Hi Mike, You mentioned new version is coming on 15th of this month. But it is not released yet. When do you have plan to release?
Farhan On Aug 3, 10:43 am, Farhan Ahmed <[email protected]> wrote: > Thanks Jim and Mike I increased time out from 1 second to 15 second > and finally array accepted the login request and initiator login. When > I tried to login from eth5 interface then it times out , anyway I have > increased timeout from 15 second to 45 second and now all good. Thanks > a lot. Yes I had already logged case with Equallogic and they are > still looking into it. > > Last suggestion is should we use multipathing over bonded interface or > multipathing over simple ethernet interfaces? multipathiong over 2 > bonded interface we are getting same throughput as we are getting > multipathing over 4 individual interfaces and array has 3 ports so my > understanding was 3 network interfaces will have more throughput as > compared to two bonded interface. But bonded interface are good in > regards of swicth failover or nic module failure , same scnerio which > I was tryin to test. Even the primary eth2 is down bonded interfcae > will have no impact. > > What do you guys think about multipath over bonded interface or > multipathing over interfaces. > > Thanks a lot for for your help guys. > > Farhan > > On Aug 2, 11:21 pm, <[email protected]> wrote: > > > > > Mike Christie wrote: > > > We can see the iscsi login pdu get sent, but we do not see a iscsi > > > response. > > > From what I can tell we just seem to see a tcp ack. Then later in packet > > > #104 > > > we see the initiator give up on waiting for a login response and > > > disconnect > > > the tcp/ip connection. > > > > However, the weird thing is that before we try the normal session login we > > > see in packet #10 that a discovery session works ok in this test. > > > > So command #1 works but command #3 does not and between that time he > > > has not done any changes to the iscsi config or network. > > > I noticed that after sending the login request (Packet #97) the initiator > > is closing the connection (Packet #104) after 1 second, which is quite soon > > - I would suggest adjusting the node.conn[0].timeo.login_timeout value back > > up to the default of 15 seconds and trying again. > > > For more help, I'd recommend contacting the Dell EqualLogic support > > organization. They're quite good, and have a lot of experience with Linux > > (including this tricky multiple-NICS-on-the-same-subnet setup): > > http://support.dell.com/equallogic/ > > > -- > > Jim Ramsay- Hide quoted text - > > - Show quoted text - -- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/open-iscsi?hl=en.
