On Wed, 2011-01-05 at 12:50 -0800, Mike Christie wrote: > On 01/05/2011 02:44 PM, Eddie Wai wrote: > > For scenarios where the shost is not being passed to bnx2i for the > > iSCSI offload connection request, the code would consult the routing > > table to select the CNIC device. > > This code path will erroneously error out if the corresponding L2 > > interface's MTU has been setup to> 1500. > > > > When have you guys actually hit this? What tools and what version does this? I believe we had run into this case in the past by not specifying the ifacename parameter in a static node but use transport of bnx2i. I would have to go back and revisit that for verification. But its a scenario our driver has supports for in the past. The jumbo MTU support was added to the shost case a while back. Adding this is more for completeness. >
-- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/open-iscsi?hl=en.
