Hi Jason,
What I can the tell you about that problem is the following.
ntopng in collector mode can only guess traffic rate from the flows it
receives from nProbe. If nProbe exports a lot of flows at once, ntopng
will consider that traffic as appearing all together, resulting into an
higher reported rate.
However, the average of the reported traffic rate should match your
actual traffic rate.
Regards,
Emanuele
On 04/20/2017 05:28 PM, Jason Ede wrote:
We’ve a mikrotik sending to nprobe and then on to ntopng.
The flow timeout on the mikrotik is set to 1minute which is the same
on nprobe, but we’re consistently seeing the traffic as showing a
higher level than the maximum interface speed. i.e. we’re seeing
~320Mbps reported on an interface which is limited to 250Mbps (and
tested at that level)
What things should we be looking at to address this reporting of speeds?
Jason
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
