Hello! > I have a script runs two successive reloads, the first one is to remove a listen port from the stream block, and the second one is to add the same port back to the stream block. It is observed that > most time the script would run into "bind() xxxx failed, Address already in use" error. After putting a sleep 1 in between these two reloads I never get that error again.
How does you send “reload” command? Through the nginx -s reload or sending signal to the master process directly? > So I guess the listening socket was not released in the time the second reload was issued? > How the listening socket is getting released during reload? The old unnecessary listening sockets will be closed after nginx master process opens the new listening sockets.
_______________________________________________ nginx mailing list [email protected] http://mailman.nginx.org/mailman/listinfo/nginx
