From: Raanan Avargil <raanan.avar...@intel.com>
There have been bugs caused by HW ULP configuration settings not being
properly cleared after cable connect in V-Pro capable systems.
This caused HW to get out of sync occasionally.
The fix ensures that ULP settings are cleared in HW after
LAN cable re-connect.
Signed-off-by: Raanan Avargil <raanan.avar...@intel.com>
Tested-by: Aaron Brown <aaron.f.br...@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirs...@intel.com>
---
drivers/net/ethernet/intel/e1000e/ich8lan.c | 2 ++
drivers/net/ethernet/intel/e1000e/ich8lan.h | 4 ++++
2 files changed, 6 insertions(+)
diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.c
b/drivers/net/ethernet/intel/e1000e/ich8lan.c
index e7ccf5f..c0f4887 100644
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.c
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.c
@@ -1328,6 +1328,8 @@ static s32 e1000_disable_ulp_lpt_lp(struct e1000_hw *hw,
bool force)
I218_ULP_CONFIG1_RESET_TO_SMBUS |
I218_ULP_CONFIG1_WOL_HOST |
I218_ULP_CONFIG1_INBAND_EXIT |
+ I218_ULP_CONFIG1_EN_ULP_LANPHYPC |
+ I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST |
I218_ULP_CONFIG1_DISABLE_SMB_PERST);
e1000_write_phy_reg_hv_locked(hw, I218_ULP_CONFIG1, phy_reg);
diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.h
b/drivers/net/ethernet/intel/e1000e/ich8lan.h
index 7d85f00..2311f60 100644
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.h
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.h
@@ -188,6 +188,10 @@
#define I218_ULP_CONFIG1_INBAND_EXIT 0x0020 /* Inband on ULP exit */
#define I218_ULP_CONFIG1_WOL_HOST 0x0040 /* WoL Host on ULP exit */
#define I218_ULP_CONFIG1_RESET_TO_SMBUS 0x0100 /* Reset to SMBus mode
*/
+/* enable ULP even if when phy powered down via lanphypc */
+#define I218_ULP_CONFIG1_EN_ULP_LANPHYPC 0x0400
+/* disable clear of sticky ULP on PERST */
+#define I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST 0x0800
#define I218_ULP_CONFIG1_DISABLE_SMB_PERST 0x1000 /* Disable on PERST# */
/* SMBus Address Phy Register */
--
2.5.0
