[PATCH v2 net-next 1/8] be2net: return error status from be_set_phys_id()

[Sriharsha Basavapatna]

From: Suresh Reddy <suresh.re...@broadcom.com>

be_set_phys_id() returns 0 to ethtool when the command fails in the FW.

This patch fixes the set_phys_id() to return -EIO in case the FW cmd fails.

Signed-off-by: Suresh Reddy <suresh.re...@broadcom.com>
Signed-off-by: Sriharsha Basavapatna <sriharsha.basavapa...@broadcom.com>
---
 drivers/net/ethernet/emulex/benet/be_ethtool.c | 23 +++++++++++++----------
 1 file changed, 13 insertions(+), 10 deletions(-)

diff --git a/drivers/net/ethernet/emulex/benet/be_ethtool.c 
b/drivers/net/ethernet/emulex/benet/be_ethtool.c
index a19ac44..2ff6916 100644
--- a/drivers/net/ethernet/emulex/benet/be_ethtool.c
+++ b/drivers/net/ethernet/emulex/benet/be_ethtool.c
@@ -720,29 +720,32 @@ static int be_set_phys_id(struct net_device *netdev,
                          enum ethtool_phys_id_state state)
 {
        struct be_adapter *adapter = netdev_priv(netdev);
+       int status = 0;
 
        switch (state) {
        case ETHTOOL_ID_ACTIVE:
-               be_cmd_get_beacon_state(adapter, adapter->hba_port_num,
-                                       &adapter->beacon_state);
-               return 1;       /* cycle on/off once per second */
+               status = be_cmd_get_beacon_state(adapter, adapter->hba_port_num,
+                                                &adapter->beacon_state);
+               if (status)
+                       return be_cmd_status(status);
+               return 1;       /* cycle on/off once per second */
 
        case ETHTOOL_ID_ON:
-               be_cmd_set_beacon_state(adapter, adapter->hba_port_num, 0, 0,
-                                       BEACON_STATE_ENABLED);
+               status = be_cmd_set_beacon_state(adapter, adapter->hba_port_num,
+                                                0, 0, BEACON_STATE_ENABLED);
                break;
 
        case ETHTOOL_ID_OFF:
-               be_cmd_set_beacon_state(adapter, adapter->hba_port_num, 0, 0,
-                                       BEACON_STATE_DISABLED);
+               status = be_cmd_set_beacon_state(adapter, adapter->hba_port_num,
+                                                0, 0, BEACON_STATE_DISABLED);
                break;
 
        case ETHTOOL_ID_INACTIVE:
-               be_cmd_set_beacon_state(adapter, adapter->hba_port_num, 0, 0,
-                                       adapter->beacon_state);
+               status = be_cmd_set_beacon_state(adapter, adapter->hba_port_num,
+                                                0, 0, adapter->beacon_state);
        }
 
-       return 0;
+       return be_cmd_status(status);
 }
 
 static int be_set_dump(struct net_device *netdev, struct ethtool_dump *dump)
-- 
2.3.0.rc2