From: Catherine Sullivan <catherine.sulli...@intel.com>
In ethtool, there is a possibility of speed getting set to 0
if advertise is set to 0 (which it is when autoneg is disabled).
We never want this to happen as the firmware will actually attempt
to set the speed to 0 sending link down, so add an extra check
to make sure this doesn't happen.
Change-ID: I62e0eeee2cbf043d8e6f5c9c9f0b92794e877f01
Signed-off-by: Catherine Sullivan <catherine.sulli...@intel.com>
Tested-by: Andrew Bowers <andrewx.bow...@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirs...@intel.com>
---
drivers/net/ethernet/intel/i40e/i40e_ethtool.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
index 928bd5a..930369c 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c
@@ -666,6 +666,13 @@ static int i40e_set_settings(struct net_device *netdev,
advertise & ADVERTISED_40000baseLR4_Full)
config.link_speed |= I40E_LINK_SPEED_40GB;
+ /* If speed didn't get set, set it to what it currently is.
+ * This is needed because if advertise is 0 (as it is when autoneg
+ * is disabled) then speed won't get set.
+ */
+ if (!config.link_speed)
+ config.link_speed = abilities.link_speed;
+
if (change || (abilities.link_speed != config.link_speed)) {
/* copy over the rest of the abilities */
config.phy_type = abilities.phy_type;
--
2.4.3
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
