Move the ip1000 driver into the expected place for gigabit cards
in the configuration menu structure. It should be under the gigabit
cards, not at the top level.
Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
--- a/drivers/net/Kconfig 2007-12-26 20:17:31.000000000 -0800
+++ b/drivers/net/Kconfig 2007-12-26 20:18:36.000000000 -0800
@@ -166,16 +166,6 @@ config NET_SB1000
If you don't have this card, of course say N.
-config IP1000
- tristate "IP1000 Gigabit Ethernet support"
- depends on PCI && EXPERIMENTAL
- select MII
- ---help---
- This driver supports IP1000 gigabit Ethernet cards.
-
- To compile this driver as a module, choose M here: the module
- will be called ipg. This is recommended.
-
source "drivers/net/arcnet/Kconfig"
source "drivers/net/phy/Kconfig"
@@ -2004,6 +1994,16 @@ config E1000E
To compile this driver as a module, choose M here. The module
will be called e1000e.
+config IP1000
+ tristate "IP1000 Gigabit Ethernet support"
+ depends on PCI && EXPERIMENTAL
+ select MII
+ ---help---
+ This driver supports IP1000 gigabit Ethernet cards.
+
+ To compile this driver as a module, choose M here: the module
+ will be called ipg. This is recommended.
+
source "drivers/net/ixp2000/Kconfig"
config MYRI_SBUS
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
