The driver would not work over fibre if other end when down then came back up (would require reloading driver). The correct way to manage the link the same way for both TP and fibre.
Resloves problem described in: http://lkml.org/lkml/2007/11/6/395 Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]> --- a/drivers/net/skge.c 2007-11-21 14:44:02.000000000 -0800 +++ b/drivers/net/skge.c 2007-11-21 14:46:34.000000000 -0800 @@ -1095,16 +1095,9 @@ static void xm_link_down(struct skge_hw { struct net_device *dev = hw->dev[port]; struct skge_port *skge = netdev_priv(dev); - u16 cmd = xm_read16(hw, port, XM_MMU_CMD); xm_write16(hw, port, XM_IMSK, XM_IMSK_DISABLE); - cmd &= ~(XM_MMU_ENA_RX | XM_MMU_ENA_TX); - xm_write16(hw, port, XM_MMU_CMD, cmd); - - /* dummy read to ensure writing */ - xm_read16(hw, port, XM_MMU_CMD); - if (netif_carrier_ok(dev)) skge_link_down(skge); } @@ -1194,6 +1187,7 @@ static void genesis_init(struct skge_hw static void genesis_reset(struct skge_hw *hw, int port) { const u8 zero[8] = { 0 }; + u32 reg; skge_write8(hw, SK_REG(port, GMAC_IRQ_MSK), 0); @@ -1209,6 +1203,11 @@ static void genesis_reset(struct skge_hw xm_write16(hw, port, PHY_BCOM_INT_MASK, 0xffff); xm_outhash(hw, port, XM_HSM, zero); + + /* Flush TX and RX fifo */ + reg = xm_read32(hw, port, XM_MODE); + xm_write32(hw, port, XM_MODE, reg | XM_MD_FTF); + xm_write32(hw, port, XM_MODE, reg | XM_MD_FRF); } @@ -1714,6 +1713,12 @@ static void genesis_stop(struct skge_por struct skge_hw *hw = skge->hw; int port = skge->port; unsigned retries = 1000; + u16 cmd; + + /* Disable Tx and Rx */ + cmd = xm_read16(hw, port, XM_MMU_CMD); + cmd &= ~(XM_MMU_ENA_RX | XM_MMU_ENA_TX); + xm_write16(hw, port, XM_MMU_CMD, cmd); genesis_reset(hw, port); -- Stephen Hemminger <[EMAIL PROTECTED]> - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
