On Thu, Nov 08, 2007 at 01:11:35PM -0600, Kim Phillips wrote: [...] > right, but whether it does or not doesn't affect your failure outcome > either I'm assuming. > > > > If it's something like 0x03, the u-boot patch will probably look like: > > > > > > if ((bcsr[12] == 0x10) && > > > (immr->sysconf.spridr == SPR_8360_REV21 || > > > immr->sysconf.spridr == SPR_8360E_REV21)) > > > /* if phy-connection-type is "rgmii-id", set it to "rgmii-rxid" */ > > > ... > > > > > > but these linux patches would remain the same (the clk and data delay > > > settings for the UCC's are still valid; it's just the PHY config > > > that is triggering your problem from what I can tell). > > > > Yup, most likely this is not UCC specific, but PHY. For some reason > > delays making harm here...
And today I was unable to reproduce yesterday's behaviour. Your patches works fine, with sixth patch and without it. With -rxid and with just -id. Though, after few resets I hit on that: - - - - U-Boot 1.3.0-rc3-g281df457-dirty (Nov 6 2007 - 18:19:35) MPC83XX Reset Status: External/Internal Soft, External/Internal Hard CPU: e300c1, MPC8360E, Rev: 21 at 528 MHz, CSB: 264 MHz Board: Freescale MPC8360EMDS I2C: ready DRAM: 256 MB (DDR2, 64-bit, ECC on) SDRAM: 64 MB (local bus) FLASH: 32 MB In: serial Out: serial Err: serial Net: UEC: PHY is Marvell 88E11x1 (1410cc2) FSL UEC0: Full Duplex switching to rgmii 100 FSL UEC0: Speed 100BT FSL UEC0: Link is up read wrong value : mii_id 1,mii_reg 2, base e0103120 read wrong value : mii_id 1,mii_reg 3, base e0103120 UEC: PHY is Generic MII (ffffffff) read wrong value : mii_id 1,mii_reg 1, base e0103120 read wrong value : mii_id 1,mii_reg 1, base e0103120 read wrong value : mii_id 1,mii_reg 5, base e0103120 FSL UEC1: Full Duplex switching to rgmii 100 FSL UEC1: Speed 100BT FSL UEC1: Link is up FSL UEC0, FSL UEC1 - - - - And UCC1 does not work at all. After another reset that message disappears and it does work again. So, I think hardware is tricking me in various ways, not your patches fault. :-( -- Anton Vorontsov email: [EMAIL PROTECTED] backup email: [EMAIL PROTECTED] irc://irc.freenode.net/bd2 - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html
