[BNX2]: Fix Serdes WoL bug.
The bug is in the code in bnx2_set_power_state() that assumes copper
devices when setting up WoL. This is no longer true after adding WoL
support for Serdes devices.
Signed-off-by: Michael Chan <[EMAIL PROTECTED]>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 78ed633..2a79ffc 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -3079,14 +3079,18 @@ bnx2_set_power_state(struct bnx2 *bp, pci_power_t state)
autoneg = bp->autoneg;
advertising = bp->advertising;
- bp->autoneg = AUTONEG_SPEED;
- bp->advertising = ADVERTISED_10baseT_Half |
- ADVERTISED_10baseT_Full |
- ADVERTISED_100baseT_Half |
- ADVERTISED_100baseT_Full |
- ADVERTISED_Autoneg;
+ if (bp->phy_port == PORT_TP) {
+ bp->autoneg = AUTONEG_SPEED;
+ bp->advertising = ADVERTISED_10baseT_Half |
+ ADVERTISED_10baseT_Full |
+ ADVERTISED_100baseT_Half |
+ ADVERTISED_100baseT_Full |
+ ADVERTISED_Autoneg;
+ }
- bnx2_setup_copper_phy(bp);
+ spin_lock_bh(&bp->phy_lock);
+ bnx2_setup_phy(bp, bp->phy_port);
+ spin_unlock_bh(&bp->phy_lock);
bp->autoneg = autoneg;
bp->advertising = advertising;
@@ -3097,10 +3101,16 @@ bnx2_set_power_state(struct bnx2 *bp, pci_power_t state)
/* Enable port mode. */
val &= ~BNX2_EMAC_MODE_PORT;
- val |= BNX2_EMAC_MODE_PORT_MII |
- BNX2_EMAC_MODE_MPKT_RCVD |
+ val |= BNX2_EMAC_MODE_MPKT_RCVD |
BNX2_EMAC_MODE_ACPI_RCVD |
BNX2_EMAC_MODE_MPKT;
+ if (bp->phy_port == PORT_TP)
+ val |= BNX2_EMAC_MODE_PORT_MII;
+ else {
+ val |= BNX2_EMAC_MODE_PORT_GMII;
+ if (bp->line_speed == SPEED_2500)
+ val |= BNX2_EMAC_MODE_25G_MODE;
+ }
REG_WR(bp, BNX2_EMAC_MODE, val);
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
