On 100mbit versions, the driver always reports gigabit speed
available. The correct modes are already computed, then overwritten.
Signed-off-by: Stephen Hemminger <[EMAIL PROTECTED]>
--- a/drivers/net/sky2.c 2007-09-19 21:35:53.000000000 -0700
+++ b/drivers/net/sky2.c 2007-09-19 21:35:57.000000000 -0700
@@ -2880,13 +2880,6 @@ static int sky2_get_settings(struct net_
ecmd->supported = sky2_supported_modes(hw);
ecmd->phy_address = PHY_ADDR_MARV;
if (sky2_is_copper(hw)) {
- ecmd->supported = SUPPORTED_10baseT_Half
- | SUPPORTED_10baseT_Full
- | SUPPORTED_100baseT_Half
- | SUPPORTED_100baseT_Full
- | SUPPORTED_1000baseT_Half
- | SUPPORTED_1000baseT_Full
- | SUPPORTED_Autoneg | SUPPORTED_TP;
ecmd->port = PORT_TP;
ecmd->speed = sky2->speed;
} else {
--
Stephen Hemminger <[EMAIL PROTECTED]>
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
