On 09/07/2007 09:19 AM, Jiri Slaby wrote:
> Hi,
>
> I found a regression in 2.6.23-rc4-mm1 (since -rc3-mm1) in e1000e driver.
> napi_disable(&adapter->napi) in e1000_probe freezes the kernel on boot.
Ok, after these changes:
diff --git a/drivers/net/e1000e/netdev.c b/drivers/net/e1000e/netdev.c
index c1c64e2..f8ec537 100644
--- a/drivers/net/e1000e/netdev.c
+++ b/drivers/net/e1000e/netdev.c
@@ -1693,10 +1693,7 @@ quit_polling:
if (adapter->itr_setting & 3)
e1000_set_itr(adapter);
netif_rx_complete(poll_dev, napi);
- if (test_bit(__E1000_DOWN, &adapter->state))
- atomic_dec(&adapter->irq_sem);
- else
- e1000_irq_enable(adapter);
+ e1000_irq_enable(adapter);
return 0;
}
@@ -4257,7 +4254,6 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
/* tell the stack to leave us alone until e1000_open() is called */
netif_carrier_off(netdev);
netif_stop_queue(netdev);
- napi_disable(&adapter->napi);
strcpy(netdev->name, "eth%d");
err = register_netdev(netdev);
I still have problems with the driver. When I do `ip link set eth0 up', ksoftirq
runs with 100 % cpu time, so I think you endlessly re-schedule some timer (or
the new napi layer?)
regards,
--
Jiri Slaby ([EMAIL PROTECTED])
Faculty of Informatics, Masaryk University
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
